English 5
WATER SUPPLY (Cold Water Only)
CAUTION
When connecting to water supply mains, local
regulations of your municipal water company
must be observed. In some areas connecting
directly to public drinking water supply may
require a backfl ow prevention device. This is
to ensure that there is no feedback of chemi-
cals into the water supply. Use a water fi lter to
avoid potential damage from dirt in the water
supply.
■ Garden hose must be at least 5/8 inch
diameter.
■ Flow rate of water supply must not fall below
2.5 GPM (gallons per minute)
■ Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
■ The water supply temperature must not ex-
ceed 122°F/50°C.
■ Never use the pressure washer to draw in
water contaminated with solvents, e.g. paint
thinners, gasoline, oil, etc.
■ Always prevent debris from being drawn into
the unit by using a clean water source. Use
additional water fi lter.
■ Do not operate pressure washer without the
water turned on.
Hardware (included)
Description Purpose Illustration Qty
A
Knob Joint Assembly 2
B
1/4" Bolt Joint Assembly 2
C
Nylon Rivet Gun Holder Assembly 4
D
Gun/Hose
Storage
Gun Holder Assembly 1
E
Nozzle Holder Nozzle Holder Assembly 1
F
High Pressure
Hose
Spray Gun Assembly 1
G
Spray Gun Spray Gun Assembly 1
ASSEMBLY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
