8 English
STEP 6:
Connect garden hose to unit`s water inlet.
STEP 7:
Connect garden hose to the cold water source
and turn water completely on.
Do not use hot water.
STEP 8:
Unlock the trigger gun safety lock. Trigger the
gun to eliminate trapped air, wait for a steady
fl ow of water to emerge from the spray nozzle.
OPERATING INSTRUCTIONS
USING THE ACCESSORIES
CAUTION
High pressure in nozzle area. Risk of injury
caused by improperly locked nozzle.
■ Make sure you hear the "click" when inserting
the nozzle tip into the quick connection.
■ Pull the nozzle to make sure it is seated
properly before operating your unit. (See
ASSEMBLY INSTRUCTIONS: Step 1)
WARNING
To avoid serious injury never point spray
nozzle at yourself, other persons or animals.
The color-coded quick connect nozzles provide a
wide array of spray widths from 0° to 65° and are
easily accessible when placed in the convenient
nozzle holder.
0° spray angle = Red nozzle
For particularly stubborn accumulation of grime.
Not recommended for soft materials like sidings,
decks, painted surfaces, cars.
25° spray angle = Green nozzle
For dirt accumulation over a large surface.
15° spray angle = Yellow nozzle
For dirt accumulation over a surface.
65° spray angle = Black nozzle
For operating with detergents or cleaning with
low pressure.
40° spray angle = White nozzle
For moderate dirt accumulation over a large
surface.
Quick connect nozzles
STEP 9:
Open fuel valve. Pull the choke rod to the "ON"
position (on a warm engine, leave the choke
rod in the OFF position).
STEP 10:
Move the engine stop switch to the "ON"
position.
STEP 11:
Pull the starter handle. If the engine fails to
start after 3 pulls, squeeze the trigger gun to
release pressure, and repeat step.
After the engine warms up enough to run
smoothly move choke rod to OFF position.
For engine details see engine manual.
To Next Page
Loading...
Need help?
General
