English 7
STEP 1:
Pull the spring-loaded collar of the wand back
to insert your choice of quick connect nozzle.
Release the collar and push the nozzle until
the collar clicks.
CAUTION
High pressure in nozzle area.
Risk of injury caused by improperly locked
nozzle.
■ Make sure you hear a "click" when inserting
the nozzle tip into the wand.
■ Pull the nozzle to make sure it is seated
properly before operating your unit.
STEP 2:
Pull back the spring loaded collar at the spray
gun and insert the high pressure hose.
Release the collar and push the high pressure
hose until the collar clicks.
CAUTION
Engine shipped without oil. Before starting
engine, fi ll with oil. Do not over-fi ll. Do not run
the engine with a high or low oil level as this
can cause engine damage.
If you have further questions regarding the
engine, please refer to the engine manual
included with the unit.
STEP 3:
Check oil level. Insert and remove dipstick
without screwing it into the fi ller neck. Check
the oil level shown on the dipstick.
Be sure the machine is level when checking
the oil level. (Refer to the engines operating
manual for seasonal grades).
We recommend that the oil be changed after
the fi rst 5 hours of use, then once every 50
hours.
STEP 4:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Do not add oil to the gasoline.
STEP 5:
Pull back the spring loaded collar at the high
pressure outlet and insert the high pressure
hose.
Release the collar and push the high pressure
hose until the collar clicks.
FULL / MAX
ADD / MIN
OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General
