Kärcher HD 10/25 S Service Manual (English)

Other manuals for Kärcher HD 10/25 S

Service Manual30 pages

Operating Instructions16 pages

Questions and Answers:

A
Adam AvilaAug 1, 2025
What to do if my Kärcher Pressure Washer turns on and off when the hand spray gun is closed?
- M
  Matthew PageAug 1, 2025
  If your Kärcher Pressure Washer cycles on and off with the hand spray gun closed, it could indicate a system tightness or pressure issue. Begin by checking the trigger gun and O-rings on the high-pressure hose for leaks, replacing them if necessary. Also, check, adjust, or replace the overflow valve, and inspect or replace the pressure retaining valve and pressure switch. Finally, check, clean, or replace the detergent check valve, and examine the pressure and suction valves for any leaks, replacing as needed.
M
Monique OrtizAug 6, 2025
How to troubleshoot a Kärcher Pressure Washer that is not running?
- S
  Sara EdwardsAug 6, 2025
  If your Kärcher Pressure Washer isn't running, several issues could be the cause. First, examine the connection cable for any signs of damage. Next, check the mains fuses and voltage. If the problem persists, there may be disturbances in the electrical system, so inspect the transformer, fuse, thermal motor protection switch, contactor, and PCB. Finally, check or replace the appliance switch and pressure switch.
W
woodcalvinAug 11, 2025
Why is my Kärcher Pressure Washer not building up pressure?
- P
  paul39Aug 12, 2025
  Several factors can prevent your Kärcher Pressure Washer from building pressure. Start by setting the nozzle to "High pressure" and cleaning or replacing it if soiled. If that doesn't work, vent the appliance to remove any air within the system. Ensure you have sufficient water supply, checking against the technical data. Also, clean the sieve in the water connection and inspect all inlet pipes to the pump for blockages. Lastly, check the pressure and suction valves for leaks and the overflow valve for proper adjustment or replacement.
C
Christopher JacksonAug 16, 2025
Why is my Kärcher Pressure Washer not sucking in detergent?
- J
  Judy FischerAug 16, 2025
  If your Kärcher Pressure Washer isn't sucking in detergent, the issue likely lies within the detergent flow. First, check and clean the detergent suction hose and filter. Then, open or check and clean the detergent dosing valve. Also, inspect, clean, or replace the detergent check valve, and check or replace the nozzle for detergent. As a last resort, replace the detergent injector.
P
Priscilla AllenAug 22, 2025
What causes a Kärcher Pressure Washer to not switch off when the hand-spray gun is closed?
- M
  Mr. Martin StricklandAug 22, 2025
  If your Kärcher Pressure Washer doesn't switch off when the hand-spray gun is closed, it usually points to a pressure issue. You should check, adjust, or replace the overflow valve. Additionally, check or replace the pressure retaining valve and the pressure switch.
D
Daniel Johnson MDAug 27, 2025
How to fix a leaky pump on a Kärcher Pressure Washer?
- M
  Mary SnyderAug 27, 2025
  If your Kärcher Pressure Washer pump is leaking, determine the source of the leak. If water is leaking between the cylinder head and piston casing, check and replace the high and low-pressure seals. If oil is leaking from the same area, replace the oil seals.