Kärcher SC 1502 User Manual

22 – English SC 1502
Power nozzle (D4)
The power nozzle is attached directly or using
the extension piece (D2) on the detail nozzle.
The power nozzle increases the emission speed
of the steam.
Application:
– removal of especially stubborn dirt
– blowing out corners, joints, etc.
Manual nozzle (E1)
Pull the terry cloth cover (E2) over the manual
nozzle.
Application:
– small, washable surfaces, such as kitchen
surfaces made of plastic, tiled walls
– windows, mirrors
– furniture fabrics
– vehicle interior, windscreens
– bath-tubs
Window nozzle (F1)
Application:
– windows
– mirrors
– glass surfaces on shower cubicles
– other glass surfaces
• Apply steam to the glass surface from a
distance of approximately 20 cm until the
surface is moistened evenly. The push the lock
(C3) to the rear to prevent an undesired
actuation of the steam switch (C4). Strip the
glass surface in straight lines from the top to
the bottom using the rubber lip of the window
nozzle. Wipe the rubber lip and the bottom
edge of the window dry after each strip.
Steam gun (C1)
You can use the steam gun without any additio-
nal accessories.
Application:
– elimination of odours and creases from
garments:
Apply steam to the hanging garment from a
distance of 10–20cm.
– removing dust from plants:
Respect a distance of 20-40 cm.
– dusting with a damp cloth:
Apply a small amount of steam to a cloth, and
then use this cloth to wipe over the furniture.
Detail nozzle (D1)
The closer you hold the nozzle to the dirty spot,
the higher the cleaning effect as temperature
and pressure of the steam reach their maximum
values immediately when they are emitted from
the nozzle.
Application:
– fittings, drains
– wash-basins, toilets
– blinds, radiators
– stainless steel, enamelled surfaces
– Removing stains:
Moisten stubborn limestone with vinegar, and
allow to react for approximately 5 minutes.
Extension piece (D2)
The extension piece is attached to the detail
nozzle.
Application:
– inaccessible gaps, joints, etc.
Round brush (D3)
The round brush is attached directly or using the
extension piece (D2) on the detail nozzle.
The round brush is not suited for the cleaning of
delicate surfaces.
Application:
– locations that are difficult to access, such as
corners and joints
– fittings, drains
5. How to use the accessories

Kärcher SC 1502 Specifications

Power

voltage	220 - 240 V
voltage in the handle	24 V
heating output	2300 W

Performance

max operating pressure	4.0 bar
admissible pressure	5.7 bar
max steam quantity	82 g/min

Capacity

max water capacity	2.0 l
boiler capacity	2.4 l
heating-up time for 1 l water	6 min/l

Weight and Dimensions

weight without accessories	7 kg
width	335 mm
length	425 mm
height	380 mm