NT30D Technical Reference and User Guide
30
Enblock
When Enblock facility is not used, the handsfree mode of the telephone is activated
through the first key pressed when it is on hook and each digit is transmitted one by one.
On the other hand, while Enblock facility is used, the telephone can be picked up only after
the entire digits are dialed and they are transmitted in a block.
Activate: Enblock facility is activated.
Deactivate: Enblock facility is cancelled.
Call Answer
By this menu, the answering type of incoming calls can be selected.
First Call: By this option, the first incoming call is answered. It is enough to lift the handset
up or use the Speaker key (or Handset/Headset key if the headset is being used) to answer
an incoming call. (This is the general use of standard phones.)
Selective: By this option, the call selected from the incoming calls list is answered. After
lifting the handset up or using the Speaker key (or Handset/Headset key if the headset is
being used), the incoming calls list must be entered by pressing ‘OK’ key. The conversation
begins if any desired call is selected from the list. (Even if there is only one incoming call,
the same process should be made to answer this call.)
Automatic: By this option, in case there is an incoming call, it is automatically answered.
The phone gets into the handsfree mode, after it has been rang once. If the headset is
being used, the call will be answered through the headset, instead of the handsfree
speaker. (So this option can also be used to facilitate the use of headset.) In case the other
party terminates the conversation, the phone automatically gets into the idle mode. But, if
the handset or headset is being used, instead of the handsfree speaker, the internal dial
tone will be heard through the handset / headset.
Quick Transfer
Thanks to this feature, during the transfer operation, even if there are more then one calls
on the park list, the last parked call can be used directly (without the need for choice).
Welcome Message
By using this menu the maximum 25 characters welcome message seen on the screen can
be changed. (Uppercase / lowercase key transition can be made by related soft key.)
Content of the welcome message is ‘KAREL’ by default.
Version
By this menu option, one can reach version information of the exchange and the telephone
set.
Software Version: E.g. AAA_11_040310
System Version: E.g. IPV2.90.8. 1
To Next Page
Loading...