KAT VR Walk C - Software Setup; KAT Gateway Software Overview

15
18
19
20
21
HMD Wire Pulley
Sensor Buckle
Trapezoidal anti-friction stripe
Square anti-friction stripe
1
1
1
1
Giveaway
PUSH
01
03
02
Installation of the HMD wire pulley (Giveaway) :
Drill a hole in the ceiling about
1m (horizontally) away from the
center of the treadmill. Place
the expansion screw sleeve into
the hole.
01
Mount the hook into the expan-
sion screw sleeve, tighten,
Thread the wire harness into the
wire harness.
Hang the wire pulley onto the hook.
0302
Software Set-Up
KAT Gateway is an independent software platform designed by KAT VR for the management of
the KAT Walk C.
Software set-up instructions
1.KAT Gateway Software Introduction