KAT VR WALK - Starting Installation - System Setup; Connecting Sensors to PC

Connecting Sensors
26 Starting Installation
1. Dial the 6-digit red dialer of KATVR-Back Sensor to match the 6-digit red code of KATVR-Central Sensor. When dialing,
note the distinction of the digital direction and the position of ON on the encoder.
2. Dial the six-digit red dialer for the wireless receiver to the same position as that for the two KATVR-Foot Sensor.
3. Connect one end of the USB-A type extension cable for the wireless receiver to the receiver and insert the other end
into the USB port of the PC.
4. Insert the other end of the KATVR-Top Sensor connecting cable into the KATVR-Top Sensor port on the side of the
KATVR-Central Sensor.
5. Connect one end of the USB-A type extension cable to the KATVR-Central Sensor and insert the other end into the
USB port of the PC.
.
USB供电线
从顶部管道
内穿入