kbice FDFM1JA02 - Initial Water Reservoir Filling; Initial Unit Flushing; Initial Ice Making Process

8
8
info@kbgoodice.com
1. Filling the water reservoir for the first time use
x Remove the reservoir door by simultaneously pulling both sides
outwards.
x Add clean potable water to MAX WATER FILL.
x Replace the magnetically attached door.
2. Flushing the unit for the first time use
x Plug the unit into power. Add Water LED will flash quickly with 5 beeps if
the water reservoir is full.
x Press and hold the Clean button for 3 seconds to start cleaning for
flushing process, the Cleaning LED illuminates (it takes 30 minutes to
complete and the Cleaning LED goes off).
x Unplug the unit when the flushing process is complete.
x Unhook the plug/holder with drain tubes out of the unit back and lower
them to a bucket or sink.
x Press and hold the release buttons on the connectors to disconnect the
plug/holder and release water.
x Reconnect and hook them back to the unit.
2. Making ice for the first time use