KBR multisys D2-MSMT-1 - Safety Notes

multisys D2-MSMT
V1.00
20742_EDEBDA0231-2516-1_EN
6
Introduction
1.3 Safety notes
In order to prevent operating errors, device operation is kept as simple as
possible. This will enable you to start your device up quickly.
In your own interest, however, the following safety notes should be read care-
fully. The applicable DIN / VDE regulations must be observed for installation!
Power supply connection, setup and operation of the device must be per-
formed by qualied personnel only. Qualied personnel as dened in the
safety notes in this user manual are those authorized to set up, ground and
mark devices, systems and circuits in accordance with applicable standards and
regulations.
To prevent re and electric shocks, the device must not be exposed to rain or
humidity!
Before connecting the device to the power supply, check whether the
local power supply conditions comply with the specications on the
device nameplate.
Caution
A faulty connection can lead to the destruction of the device!
For device connection, the data given in the connection chart must be
complied with (see “Connection diagram”) and the connection lines must be
voltage-free. When wiring, always ensure that all wiring material used is neither
damaged nor defective and that the polarity is correct!
In order to ensure proper and safe product operation, transport, store, install
and assemble the device in accordance with the specications and carefully
operate and maintain it.
A visibly damaged device must generally be considered unt for use and dis-
connected from the power supply!
Error detection, repair and maintenance work may only be carried out in our
facilities or after contacting our service team. Opening the device unauthorized
will render your warranty null and void. Correct operation can no longer be
guaranteed!
Opening the device may expose live parts. Capacitors in the device may still be
charged, even if the device has been disconnected from all voltage sources.
Do not operate open devices under any circumstances!
Systems that are at risk from lightning strikes must feature lightning protection
for all input and output lines.