Keba KeContact P20 User Manual (English)

Other manuals for Keba KeContact P20

User Manual20 pages

Frequently Asked Questions10 pages

Manual128 pages

Installation Guide60 pages

Installation Manual48 pages

Questions and Answers:

C
Cynthia SerranoAug 2, 2025
What to do if my Keba KeContact P20 standard plug cannot be unplugged?
- C
  christopherbarberAug 3, 2025
  If you cannot unplug the standard plug from your Keba Battery Charger, it might be because the charging procedure wasn't correctly ended by the vehicle. Try ending the charging procedure according to the vehicle manufacturer's instructions. Also, the plug may not be able to be unlocked under tension. Press the plug in and connect to the vehicle again, then end the charging procedure again.
E
Emily Cole DDSAug 8, 2025
Why is the charging procedure not started on my Keba KeContact P20 Battery Charger?
- H
  Henry CobbAug 8, 2025
  The charging procedure on your Keba Battery Charger might not start due to several reasons: the plug was not plugged in correctly (unplug and plug in connector again), the plug may possibly be dirty in the locking area or damaged (clean the plug or have it replaced), the vehicle does not require energy or it has a fault (check vehicle), or the vehicle is programmed to charge at a later starting time.
M
mcgeechristineAug 15, 2025
What to do if the Status LED flashes red on Keba Battery Charger?
- K
  Kristina HollowayAug 15, 2025
  If the status LED on your Keba Battery Charger flashes red, it indicates a malfunction. First, check the possible causes of error for the malfunction. You can also try switching off the supply voltage of the charging station (installed or superordinate RCD and line circuit breaker), unplugging the charging cable from the charging station, and then switching the voltage supply on again. In case of defective, please contact your service partner.
L
Lee CrossAug 20, 2025
Why is the Keba Battery Charger taking longer to charge or not fully charging my vehicle?
- S
  Sarah Bell MDAug 21, 2025
  A longer charging time or a vehicle not fully charged with your Keba Battery Charger can be caused by power reduction due to excessive temperature by the vehicle or the charging station. Protect the vehicle and the charging station from direct sunlight during the charging procedure (carport, garage, etc.). Also, perform a visual inspection of the plug and socket device to see if it is dirty, worn or damaged. Another reason could be no enable due to external control device (energy supplier, photo- voltaic system, etc.).
J
John Hartman DDSAug 27, 2025
How to fix a Keba KeContact P20 when the status LED does not light up?
- J
  Justin ThompsonAug 27, 2025
  If the status LED on your Keba Battery Charger does not light up, it could be due to no voltage supply. Check the RCD and line circuit breaker and switch on, if necessary. In case of defective, please contact your service partner.

Keba KeContact P20 Specifications

General

Charging Power	up to 22 kW
Input Voltage	230/400 V
Connector Type	Type 2
Protection Class	IP54
Charging Modes	Mode 3
Operating Temperature	-25 °C to +50 °C
Protection Features	Overvoltage, Overcurrent, Short Circuit