Need help?Do you have a question about the Keba KeContact P30 c Series and is the answer not in the manual?
General| Charging Power | Up to 22 kW |
|---|---|
| Output Voltage | 230/400 V AC |
| Protection Rating | IP54 |
| Charging Modes | Mode 3 |
| Rated Voltage | 400 V AC |
| Rated Current | 32 A |
| Output Current | 32 A |
| Connector Type | Type 2 |
| Communication Interfaces | Ethernet, Modbus, OCPP |
Document is an extension to supplied manuals and requires compliance with all instructions.
Explains symbols for DANGER, WARNING, CAUTION, Caution, ESD, and Information.
User must ensure the document is valid for their present product.
Document is for persons with technical knowledge and programming skills.
Lists requirements for using Modbus TCP functionality (firmware, hardware, network).
States specifications are subject to change and excludes liability claims.
Provides links for Modbus TCP standards and KEBA downloads.
Introduces Modbus TCP as a standardized communication protocol for data exchange.
Describes the 6 sections of a Modbus TCP frame and its attributes.
Register 1000 for charging station state, lists supported values.
Register 1004 for charging cable state, lists supported values.
Register 1006 for charging station error code, explains value interpretation.
Register 1008 for measured current on phase 1 in mA.
Register 1010 for measured current on phase 2 in mA.
Register 1012 for measured current on phase 3 in mA.
Register 1014 for the serial number of the charging station.
Register 1016 for the type and features of the charging station.
Register 1018 for firmware version, explains decimal to hex conversion.
Register 1020 for active power in milliwatts.
Register 1036 for total energy consumption in watt-hours.
Register 1040 for measured voltage on phase 1 in volts.
Register 1042 for measured voltage on phase 2 in volts.
Register 1044 for measured voltage on phase 3 in volts.
Register 1046 for power factor (cos phi) in 0.1%.
Register 1100 for the maximum charging current in mA.
Register 1110 for max supported current by hardware.
Register 1500 for RFID card serial number (UID).
Register 1502 for transferred energy of the current charging session.
Register 5004 to set charging current, affects permanent value.
Register 5010 to set energy transmission for session termination.
Register 5012 to unlock the charging station plug when suspended.
Register 5014 to enable or disable the charging station, stops active process.
To Next Page
