P30 Introduction
Modbus TCP Programmers Guide V1.02
4
© KEBA
1 Introduction
This programmers guide provides the information required to use the Mod-
bus TCP interface for sending or reading parameters to certain registers of
P30 charging station. The Modbus TCP interface can be used for example
by energy managers to calculate the actual current and react correspond-
ingly to reduce or increase the charging current. The Modbus TCP interface
can also be used to control/limit the power consumption of connected elec-
tric vehicles.
Fig.1-1: Schematic overview (example)
1.1 Safety instructions
This document is an extension to the supplied manuals of P30.
You must comply with all instructions and safety instructions in the
supplied manuals!
To Next Page
Loading...
Need help?
General
