Authorization process
17/128
2.3 Programming RFID user cards (optional)
The authorization by an RFID master card is necessary for the programming. The program-
ming mode can be activated and deactivated with the RFID master card which is programmed
during commissioning of the charging station.
Activating programming mode:
Hold the RFID master card in front of the RFID sensor and wait for the signal tone.
Programming RFID user card:
Hold the new RFID user card in front of the RFID sensor within 5 seconds and wait for the signal tone.
Ending programming mode:
To confirm, hold the RFID master card in front of the RFID sensor again within 5 seconds and wait for
the signal tone.
The RFID user card is now programmed.
Deleting RFID user cards:
Deleting all stored RFID user cards is only possible by opening the device (see installation manual).
To Next Page
Loading...
