Authorization process
18/128
2.4 Installing/removing the cylinder lock
Cylinder lock with key…
Device versions with key switch have a cylinder lock in-
stalled as standard. If needed, the cylinder lock can be
replaced according to the following instructions.
Requirements…
The cylinder lock must fulfill the following requirements:
● Profile half cylinder according to EN 1303 or DIN
18252
● Dimension A = 30 mm (for A=31 mm a minimal
overhang occurs in the housing)
● Adjustable lock nose
Preparing the cylinder lock…
Adjust the angle of the lock nose [S] so that it faces
up vertically when the key is in the removal posi-
tion.
Adjusting the lock nose…
The adjustment of the lock nose angle normally oc-
curs as follows:
Use a thin object to press in the code pin and push
the lock nose into the desired position.
To Next Page
Loading...
