KC-P30 x-series Introduction
Configuration manual V4.09
6
© KEBA
1.2 Purpose of the document
This document describes the configuration of the advanced features of P30
x-series after it has been installed. This includes, among other things, the
description of the settings in the web interface.
This document is an extension to the supplied manuals of P30 x-series.
You must comply with all instructions and safety instructions in the
supplied manuals!
1.3 Requirements
This document contains information for persons with the following require-
ments:
Target group Required knowledge and abilities
Electrician
Person who, due to his or her special training, expertise and experi-
ence as well as knowledge of current standards, is able to assess
the work performed and the possible hazards.
Knowledge of:
● current valid safety information,
● the mode of operation of the charging station,
● the displays and operating elements of the charging station,
● basics of network technology,
● basics of IT,
● diagnostic options,
● systematic fault analysis and rectification,
● the setting options on the charging station.
1.4 Warranty
Only general maintenance work that is expressly permitted by KEBA may be
performed. Any other tampering to the device will result in a loss of the war-
ranty claim.
WARNING!
Risk of electric shock and fire hazard!
After the front part has been opened, product safety can no longer be guar-
anteed.
Only those covers that are described in the procedure instructions are al-
lowed to be opened. If one of the covers is sealed by a lead seal, it is not
permitted to be opened by unauthorized persons. If the lead seal is broken,
the device loses its specific suitability for use and may no longer be put into
operation due to the resulting incorrect identifier.
To Next Page
Loading...
Need help?
General
