Quick Start Guide
3
Сonnect a mobile device to your Keenetic device via Wi-Fi.
The default Wi-Fi name (SSID) and Wi-Fi password are
printed on your Keenetic device’s back label along with
a QR code that will automatically connect your mobile device
to the Keenetic device’s Wi-Fi when scanned. Alternatively,
сonnect a computer to any gray Ethernet port on your
Keenetic device using the included Ethernet cable.
Installing Your
Keenetic Titan
For technical support or other information, please visit
help.keenetic.com
AC2600 Dual Band Mesh Wi-Fi Gigabit Router with
Dual Core CPU, a 5-Port Gigabit Smart Switch,
SFP Combo Port, USB 2.0 and USB 3.0 Ports
Model: KN-1810
4
Once connected, an Initial Setup Wizard window will appear on
your mobile device / computer. If the Wizard does not appear,
using a browser go to my.keenetic.net.
Note: If the Initial Setup Wizard doesn’t appear, please refer
to the Frequently Asked Questions section below.
5
In the Initial Setup Wizard window that appeared, select the
configuration option.
To create a new network and connect it to the Internet, choose
the appropriate connection type and follow the setup instructions.
To extend an existing network and add this Keenetic device as
a Wi-Fi extender, choose the ‘To switch to Wi-Fi Extender Mode’
option and follow the setup instructions.
2
Connect your Keenetic device to a power
source. Check that both the Status LED C and
Wi-Fi LED D are illuminated and not blinking.
1
Position your Keenetic Titan (hereinafter ‘Keenetic device’)
within cable lengths of Ethernet and power outlets. Place
your Keenetic device in an open area for better wireless
coverage.
10:00
Welcome to
Your Keenetic
Next
To Next Page
Need help?
General
