KeepRite K40-CU-IM-13 - Bitzer Compressor Oil Compatibility; Carlyle Compressor Oil Compatibility

25
Due to the extreme hygroscopic (moisture absorbing) characteristics of Polyol Ester (POE) oils,
systems MUST NEVER
be left open to the atmosphere for any extended period of time. Simply pulling a
deep vacuum on the system during the evacuation and dehydration procedure WILL NOT remove
moisture that is absorbed into POE oils.
Refrigeration Oils--Bitzer Semi-Hermetic Reciprocating Compressors:
2KC-05.2(Y) to 6F-50.2(Y)
Mobil EAL Arctic 32 A* A* P
Castrol Icematic SW32 A* A* P
Suniso 3GS A A
Suniso 4GS A A
Capella Oil WF32 A A
Capella Oil WF68 A A
Esso Zerice R68 A A
Zerol 150 P P
Zerol 300 P P
Icematic 2284 P P
Esso Zerice S46 P P
Esso Zerice S68 P P
Shell Clavus SD 2212 P P
Esso Zerice R46 A A
Legend: P = Preferred A= Acceptable Alternative
- Compressor with "Y" designation are factory charged with polyolester oil
* NOTE: When operating (H)CFC with ester oils the quantity of refrigerant dissolved in the oil is
more than doubled as compared with conventional lubricants. Special care should be
taken. Refer to Bitzer Technical Bulletin KT-510-2, section 5 for additional information.
Not
Acceptable
Not
Acceptable
Not
Acceptable
Mineral Oils
Alkyl Benzene
A/B M/O
Mix
HFC's
R-134a, R-404A,
R-507, R-407C
Polyol Ester
Lubricant Type
(H)CFC
R-22
Interim Blends
R-401A, R-401B, R-402A,
R-408A, R-409A,
(MP-39, MP-66, HP-80,
FX-10, FX56)
ICI (Virgina KMP)
Emkarate RL32S
A* A* P
Refrigeration Oils--Carlyle Semi-Hermetic Reciprocating Compressors:
06D/E and 06CC
HFC's
R-134a
,
R-404A
,
R-507
,
R-407C
Totaline P903-1001,1701 A
Castrol E68 A
ICI Emkerarate RL68H A
CPI CP-2916S A
CPI Solest 68 A
BP Marine Enersyn MP-S68
A
Witco Suniso 3GS A
Totaline P903-2001 A
Texaco Capella Oil WFI-32-150 A
IGI Cryol -150 A
Shrieve Zerol-150 A
A = Approved
Some restrictions may apply.For further information consult Carlyle factory or Carlyle web site.
Mineral/Alkyl
Benzene
Not Approved
Lubricant Type (H)CFC
R-22
Polyol Ester
Not Approved