35
Start-up Information
Important: This start-up information should be completely filled in on each installation and remain with the unit
as a permanent record for future reference. Future service work may be logged on the proceeding page. Service
parts list are attached to the back cover. PLEASE PRINT LEGIBLY
Name & address of installation______________________________________________________
__________________________________________________________________________
Name, address, phone & fax # of Installing contractor _______________________________________
__________________________________________________________________________
__________________________________________________________________________
Type of System (Cooler, Freezer, etc…) ___________ Design Box Temperature _____
o
F
Condensing Unit System start-up date ______________________
Unit model # _________________________________ Unit serial #
____________________________
Compressor model #___________________________ Compressor serial #_______________________
Evaporator(s) QTY ______
Unit model #
____________________________ Unit serial #____________________________
Unit model #____________________________ Unit serial #____________________________
Evaporator(s) unit electrical rating: Volts__________Phase__________Hz __________
Voltage at evaporator terminals: L1/L2___________ L2/L3 ____________ L1/L3__________
Amperage at evaporator: L1___________ L2____________ L3______________
Expansion valve - Manufacturer________________________________ Model #
____________________
Evaporator drain line trapped outside of box____Yes _____No
System Conditions (Record just before desired box temperature is reached)
Refrigerant Type________Total Charge________System evacuation # of times______Final micron
_______
Ambient at start-up ______
o
F Operating box temperature______
o
F
Thermostat setting ______
o
F Defrost settings ______ / day Minutes fail safe ______
Condensing unit electrical rating: Volts__________Phase__________Hz __________
Voltage at compressor terminals: L1/L2___________ L2/L3 ____________ L1/L3__________
Amperage at compressor: L1___________ L2 ____________ L3 ___________
Compressor discharge pressure__________psig Compressor suction pressure__________psig
Discharge line temperature at compressor______
o
F Suction line temperature at compressor______
o
F
Superheat at compressor ___
o
F
Suction line temperature at evaporator TX valve bulb______
o
F Superheat at evaporator______
o
F
Comments:________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
To Next Page
Loading...
