EasyManuals Logo

KEEWAY QJ50T-21U User Manual

KEEWAY QJ50T-21U
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
144
Remove the spacer and the locating pin.
Remove the clutch spindle and gear of output shaft.
Remove the middle shaft and the middle gear.
16.3.2 Check the Output Gearbox Cover
Check abrasion and damage of the clutch spindle, gear and
bearing.
Exchange gearbox cover bearings.
Press the clutch spindle when the clutch spindle bearings are
exchanged; remove it from the gearbox cover.
Note:
Removed bearing cannot be used any more. It shall be
replaced.
Use special tools to dismantle the bearing and the oil seal.
Remove the oil seal from the gearbox and knock the bearing out.
Note:
Removed bearing cannot be used any more. It shall be replaced.
Use special tools to dismantle the bearing and the oil seal.
16.4 Installation
Install it in reverse order.
Note:
Use special tools to assemble the bearing and the oil seal to avoid any damage.
Middle shaft
Middle gear
Spacer
Output shaft gear
Clutch
spindle
Clutch main shaft
Oil seal bearing

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KEEWAY QJ50T-21U and is the answer not in the manual?

KEEWAY QJ50T-21U Specifications

General IconGeneral
BrandKEEWAY
ModelQJ50T-21U
CategoryScooter
LanguageEnglish

Related product manuals