Maintenance Rules
Metric tools are preferable for the maintenance of this motorcycle.
Improper tools may cause damage.
Clean up the surface of components or assembly parts before
removing or opening the shield for maintenance, which can
prevent dirt from falling into the engine, chassis or braking
system.
Wash and dry parts with air compressor after disassembly and before measurement of attrition value.
Solvent or oil can easily damage aging rubber articles. Check rubber before reassembly and replace rubber if
necessary.
套：boot
When loosening assembly parts, please start from outside to
inside. Small assembly parts shall be loosened first.
Complex assembly parts, such as gearbox, shall be stored in
proper order for facilitating installation in the future.
Please specially note important connections before disassembly.
Replace parts which will not be in use before disassembly.
To Next Page
Loading...
Need help?
General
