!Xlf triggered scanning was selected, press TRIGGER fo
start the scan. One trigger per channel will be required.
lO.To exit the scan mode, press SCANNER 0.
scan Mode
1. Press SHIFT SCAN SETUP, and program 2/4pole mode.
Z.Press NEXT. then use uprangeldownrange to select
SCAN mode.
3.Press NEXT, and select ratio on or off as desired.
4.Press NEXT to return to normal aperation.
S.&x interval scanning, use TRIG SETUP to select con-
tinuous trigger mode, delay, and to program the desired
interval between setsof channels.
&For trigge& scanning, use TRIG SETUP to select one-
shot trigger mode and delay.
7.Press SCANNER, then program the desired channel limit
haximum limit = 4 for 4-p& mode).
S.lf interval scanning was selected, the unit will begin
scanning one set of channels per interval. The closed
channel will appear in the right-most digit of the display.
S.lf triggered scanning was selected, press TRIGGER to
start the scan. One triggerper set of channels will be
required.
lO.Ta exit the scan mode, press SCANNER 0.
Interval Ema store Scanning
1. Press SHIFT TRIG SETUP, and select CONTINUOUS trig-
ger mode.
2.Press NEXT, and program desired trigger delay
lOmsec-999.999sec,.
11
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General