HP SERIES 200 and 300
The following program sends a command string to the
Model 199 from a Hewlett-Packard Series 200 or 300 corn-
puter and displays the instrument reading Wing on the cam-
puter CRT. The computer must be equipped with the HP16
Interface and BASIC 2.0. 3.0, or 4.0.
1. Fmm the front panel, set the primary address of the Model
199 to 26.
2.Wth the power off, connect the Model 199 to the HPIB
interface installed in the computer.
3.Enter the computer EDIT mode.
4,Enter the lines in the program below, using the ENTER
key after each line
6. Run the pmgram. and type in the desired command string
at the command prompt. For example. to place the instru-
mentin ACV and autorange. type in FlROX and press the
ENTER key.
6.The instwment reading string will then appear on the CRT
A typical display is: NACV+0.000OOOE+ 0.
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...