Keithley 2430

Detecting calibration errors ....................................................... B-8
Reading the error queue ..................................................... B-8
Error summary .................................................................... B-8
Status byte EAV (Error Available) bit ............................... B-9
Generating an SRQ on error ............................................... B-9
Detecting calibration step completion ..................................... B-10
Using the *OPC? query .................................................... B-10
Using the *OPC command ............................................... B-10
Generating an SRQ on calibration complete .................... B-11
C Calibration Programs
Introduction ............................................................................... C-2
Computer hardware requirements ............................................. C-2
Software requirements ............................................................... C-2
Calibration equipment ............................................................... C-2
General program instructions .................................................... C-2
Program C-1 Model 2430 calibration program .................. C-4
Requesting calibration constants ............................................... C-7
Program C-2 Requesting calibration constants .................. C-7