In many systems, when the instrument is powering on, the
outputs may be in an unknown state until they are properly
initialized. Make sure the design can tolerate this situation
without causing operator injury or hardware damage.
To keep users safe, always read and follow all safety warnings
provided with each of the instruments in your system.
Install the instrument
You can use the Model 2461 on a bench or in a rack. Please see the
instructions that came with your rack-mount kit if you are installing
the Model 2461 in a rack.
To prevent damaging heat build-up and ensure specified
performance, make sure there is adequate ventilation and air flow
around the instrument to ensure proper cooling. Do not cover the
ventilation holes on the top, sides, or bottom of the instrument.
Position the instrument so that it is easy to reach any disconnecting
devices, such as the power cord and the power switch.
To Next Page
Loading...
