In this section:
About this section ..................................................................... 7-1
Where can I find updated drivers? ............................................ 7-1
How do I upgrade the firmware? .............................................. 7-2
Why can't the 2470 read my USB flash drive? ......................... 7-2
How do I change the command set? ........................................ 7-3
Why am I getting a 5074 event code? ...................................... 7-4
How do I save the present state of the instrument? ................. 7-4
Why did my settings change? ................................................... 7-5
What are the Quick Setup options? .......................................... 7-6
About this section
This section helps you find answers to the most common questions encountered with the 2470. For
additional FAQs, see "Frequently Asked Questions (FAQs)" in the 2470 Reference Manual.
Where can I find updated drivers?
For the latest drivers and additional support information, see the Keithley Instruments support
website.
To see what drivers are available for your instrument:
1. Go to tek.com/support
.
2. Enter the model number of your instrument.
3. Select Software from the filter list.
4. Select Driver from the filter list
If you use the native LabVIEW
TM
or IVI driver, you must configure the 2470 to use the SCPI
command set. For information on changing the command set, refer to
How do I change the
command set? (on page 7-3)
Section 7
Troubleshooting FAQs
To Next Page
Loading...
Need help?
General
