2600S-900-01 Rev. C / January 2008 Return to Section Topics 1-5
Series 2600 System SourceMeter
®
Instruments User’s Manual Section 1: Front and Rear Panel Operation
3. Range keys:
and Selects the next higher or lower source or measure range.
AUTO Enables or disables source or measure auto range.
4. Output control and LED status indicator:
OUTPUT ON/OFF Turns source output on or off.
LED indicator Turns on when output is on.
5. navigation wheel and CURSOR keys:
When in source edit, use CURSOR keys for cursor control and then turn the to change a source or
compliance value. The can also be used to enable or disable the source edit mode.
When in a menu, use the CURSOR keys or for menu item cursor control. When displaying a menu
value, use the CURSOR keys for cursor control and turn the to change the value. Pressing the opens
a menu item, or selects a menu option or value.
6. Display indicators (not shown):
EDIT Unit is in the source editing mode.
ERR Questionable reading or invalid cal step.
REM Unit in remote mode.
TALK Unit addressed to talk.
LSTN Unit addressed to listen.
SRQ Service request.
REL Relative mode enabled.
FILT Analog filter or Averaging filter is enabled.
AUTO Auto source or measure range selected.
ARM Unit armed and ready to run.
TRIG External triggering selected.
* (asterisk) Readings being stored in buffer.
To Next Page
Loading...
Need help?
General
