Models affected:
Models 3706A, 3706A-S, 3706A-NFP, 3706A-SNFP.
Symptom:
When identical relays are closed/opened in two or more consecutive scan-steps, the Channel Ready
trigger event is generated only when the first identical step is executed. It is not generated when the
subsequent identical steps are executed.
Workaround:
None.
Resolution:
This issue has been corrected.
Models affected:
Models 3706A, 3706A-S, 3706A-NFP, 3706A-SNFP.
Symptom:
An error occurs when scan.add() used in a loop for more than 91 times when multiple switching cards
are used.
Workaround:
None.
Resolution:
This issue has been corrected.
Models affected:
Models 3706A, 3706A-S, 3706A-NFP, 3706A-SNFP.
Symptom:
Autoranged 4-wire resistance measurement of a 10 ohm resistor returns overflow on the 10 ohm
range when the lead resistance exceeds the Maximum 4WΩ Lead Resistance specification for the
range.
Workaround:
None.
Resolution:
This issue has been corrected. For the case of a 10 ohm resistor with excessive lead resistance, the
autoranging process will now bump the range up to the next highest range (100 ohms) and take the
measurement.
To Next Page
Loading...
Need help?
General
