02
Operating instructions
smart slider - Operating instructions
02. Electric operation
2.3 If mode: SEMI AUTOMATIC operation
This means that when the user presses the control button, the automation will open/close the sliding unit almost
completely automatically, up to approximately 25 cm from the end (or the danger zone for pinching). To open/close
the sliding assembly completely (the last 25cm), keep the command button pressed until the sliding assembly is
fully open/closed. The user is responsible for keeping an eye on the moving assembly, making sure that no one is in
the danger zone, and in the event of abnormal situations he can immediately release the control button to stop the
action.
TO OPEN
Give an open command via the control button, the sliding part will open automatically and stop about 25 cm
before the end. From here you have to give again an open command via the control button, at this time keep the
button pressed until the sliding part is fully open. The system stops itself when fully open.
TO CLOSE
Give a close command via the control button, the sliding part will close automatically and stop about 25
cm before the end. From here you have to give again an close command via the control button, at this time keep
the button pressed until the sliding part is completely closed. The system stops itself when completely closed.
IF YOU STOP PRESSING THE CONTROL BUTTON DURING THE LAST 25CM, THE SLIDING WILL
STOP IMMEDIATELY WITH MOVING. ALWAYS REMEMBER THERE IS A SMALL DELAY DEPENDING OF
THE WEIGHT AND HOW LARGE THE LEAF IS.
ALWAYS TAKE CARE, BEFORE AND WHEN OPERATING THE SLIDING UNIT, THAT THE ENTIRE
SLIDING ZONE IS FREE OF OBSTACLES AND/OR PERSONS AND THIS DURING THE ENTIRE RUN
PERIOD.
5
Keller minimal windows
®
| 997-00220 | 05-2022
Keller minimal windows
®
To Next Page
Loading...
Need help?
General