03
Operating instructions
smart slider - Operating instructions
03. Maintenance and care
3.1 Care of your smart slider
®
system
3.2 General safety regulations for maintenance and service
Do not treat with caustic or aggressive products. Use water and mild polish to clean the motor u-housing.
• This manual describes the maintenance of the automation.
• Adding or omitting parts can adversely affect the functioning and thus the safety of the system is therefore
strongly forbidden!
• All indications about mounting right / left always apply from the inside, so from inside to outside view!
• All dimensions are in cm’s unless otherwise stated.
• You should keep this maintenance manual in a safe place.
• Make sure the power is off and stays off when doing electrical work!
• Wear personal safety measures such as gloves and clothing as well as safety shoes when servicing the system
• Make sure that you can always perform your work stably.
• Secure the installation/maintenance area with a safety tape so that third parties (children!) are kept at a
distance.
• Provide sufficient light.
IF ANYTHING IS UNCLEAR ABOUT THE MAINTENANCE OR SERVICE INSTRUCTION, PLEASE
CONTACT YOUR DISTRIBUTOR. TO AVOID SERIOUS PERSONAL INJURY, ALL DIRECTIONS AND
INSTRUCTIONS IN THIS SERVICE MANUAL MUST BE FOLLOWED CAREFULLY READ AND ADHERED
TO.
A LONG SERVICE LIFE OF YOUR AUTOMATION IS ONLY GUARANTEED WITH REGULAR
MAINTENANCE, CARE AND INSPECTION. IF THE MAINTENANCE IS NOT CARRIED OUT, IS
NEGLECTED, AND IS CARRIED OUT LEVEL 2 BY AN UNQUALIFIED COMPANY, YOUR SUPPLIER/
DISTRIBUTOR CANNOT BE HELD LIABLE FOR THE CONSEQUENCES OF THIS SHORTCOMING.
INSPECTION OF THE AUTOMATION MUST BE CARRIED OUT AT LEAST 1X PER YEAR BY A
QUALIFIED COMPANY AND MUST ALSO BE RECORDED IN WRITING.
7
Keller minimal windows
®
| 997-00220 | 05-2022
Keller minimal windows
®
To Next Page
Loading...
Need help?
General