02
Operating instructions
smart slider - Operating instructions
02. Electric operation
2.1 Principle
2.2 If mode: DEAD MAN'S operation
The horizontally sliding unit is driven by an electric motor that is linked to your sliding mechanism via a toothed belt
entirely via the flight bar.
The whole movement is controlled via a “dead man's control”, that is, the user must press down the control button
until the sliding has completed its full cycle. The movement will stop as soon as the control button is released. The
user is therefore responsible for keeping an eye on the sliding operation, making sure that no one is in the danger
zone, and immediately release the button in case of abnormal situations.
To open
Give an open command via the control button and hold it down until the sliding part is fully open.
The system stops itself when fully open.
To close
Give a close command via the control button and hold it down until the sliding part is completely closed.
The system stops itself when fully closed.
IF THE CONTROL BUTTON IS RELEASED, THE SLIDING WILL STOP IMMEDIATELY WITH MOVING.
ALWAYS REMEMBER THERE IS A SMALL DELAY DEPENDING OF THE WEIGHT AND HOW LARGE
THE LEAF IS.
ALWAYS TAKE CARE, BEFORE AND WHEN OPERATING THE SLIDING UNIT, THAT THE ENTIRE
SLIDING ZONE IS FREE OF OBSTACLES AND/OR PERSONS AND THIS DURING THE ENTIRE RUN
PERIOD.
4
Keller minimal windows
®
| 997-00220 | 05-2022
Keller minimal windows
®
To Next Page
Loading...
Need help?
General