To Next PageTo Next Page
Need help?Do you have a question about the Kelly KLS7230N and is the answer not in the manual?
Introduces the KLS-N controller, its features, and programming options.
Details the various operational capabilities and protective features of the controller.
Lists the key technical attributes and capabilities of the KLS-N controller.
Outlines technical details like operating frequency, voltage, current, and temperature ranges.
Explains the naming convention used for Kelly BLDC motor controllers.
Provides instructions and diagrams for physically installing the controller.
Details pin definitions and wiring diagrams for connecting the controller.
Outlines a procedure for verifying correct installation before operation.
Configures basic parameters like voltage limits, current, and throttle settings.
Sets motor-specific parameters like poles, sensor type, and temperature settings.
Adjusts advanced parameters for acceleration, braking, and control response.
Explains the crucial process to match the controller to the motor.
Provides instructions for the exterior cleaning of the controller.
Describes how to connect and configure the controller using software.
Introduces the KLS-N controller, its features, and programming options.
Details the various operational capabilities and protective features of the controller.
Lists the key technical attributes and capabilities of the KLS-N controller.
Outlines technical details like operating frequency, voltage, current, and temperature ranges.
Explains the naming convention used for Kelly BLDC motor controllers.
Provides instructions and diagrams for physically installing the controller.
Details pin definitions and wiring diagrams for connecting the controller.
Outlines a procedure for verifying correct installation before operation.
Configures basic parameters like voltage limits, current, and throttle settings.
Sets motor-specific parameters like poles, sensor type, and temperature settings.
Adjusts advanced parameters for acceleration, braking, and control response.
Explains the crucial process to match the controller to the motor.
Provides instructions for the exterior cleaning of the controller.
Describes how to connect and configure the controller using software.
General| Rated Current | 30A |
|---|---|
| Operating Frequency | 16kHz |
| Standby Battery Current | <0.5mA |
| Weight | 0.42kg |
| Dimensions | 128mm * 85mm * 44mm |
| Phase | 3-phase |
| Power | 2160W |
| Protection | Over-current, Over-voltage, Over-temperature |
| Communication | CAN |
