Loading the Salt into the Softener
Always use salt in tended for use with dish washers.
The salt container is located beneath the lower rack and should be filled as follows:
Remove the lower basket and the n unscrew and rem ove the cap from the salt
container.
If you ar e fil li ng the c ontaine r for the fi rs t ti me , fil l 2/3 o f its volume with water.
Place the end of the funnel(supplied) into the hole and introduce about 2kg of
salt .It is normal for a small amount of water to com e out of the sal t container
Carefully screw the cap back on.
1
2
4
3
Adjusting Salt Consumption
Unscre w the cap from the salt containe r.
Ther e is a ri ng on the c onta ine r wi th a n ar row on it (s ee Figur e to the side), if
necessary, rotate the ring in the antic loc kw ise direction fr om the "-" Se tt ing
towa rd the "+" si gn, bas ed on the har dne ss of the w ate r b ei ng us ed. It i s
recommended that adjustments should be made in accordance with the fo llowing
schema:
1
2
1.
2.
The salt conta iner must be refilled when the salt warning light comes on. Though the salt container is filled
enough, the i ndicator light may not black out be fore the salt ful ly dissolve .
If the re a re s p il ls of the s alt, a soa k progr am could be run to wipe them out.
WATER HARDNESS
Clarke Degrees
dH
mm ol /l
Select or Pos it io n
Sal t consumption
(g ram/cycle)
Auto nomy
(cycles/2 kgs)
0~14 0~10 0~ 1.7
/
0/
14~3 6 18~44 1.8~ 4.4
-
20 6 0
36~71 45~89 4.5~8.9 MED 40 40
71
89 8. 9
+
60 2 5
Contact your local water board for information on the hardness of your wate r supply.
The har dness of the wa ter varies from pla ce to place. If hard wate r is use d in the dishw asher, depos its will form on the dishes
and utensils.
The app l ia nce s is equipped with a speci al softener that uses a salt spe cifi ca ll y designed to eliminate lim e and minerals from the
water .
WATER SOFTENER
NOTE:
The dis hwa she r is de si gned to allow for adj usting the amou nt of sal t consum ed based on the hardness of the water used.
This is intended to optimize and customi ze the level of salt consumption so that the salt consumpti on could be set pr oce ed as
follows:
There are two ways to reduce the hardness: one way is using water softener, the other is u sing
detergent.
water
If your model have not water softener, you may skip this section.
NOTE: