Kelvinator Gas Continuous Flow hot water system remote controller 1 3
Remote controller (optional 60°C models only)
The water heater can be installed with a remote controller.
Each remote controller has two functions which can adjust
the set temperature and indicate the error code on the
remote controller.
• The set temperature can be adjusted only when the
priority lamp on the remote controller is lit. Press the
priority button on the controller to set it to priority.
Make sure there is no water owing through the water
heater when you do this.
• If there is a problem with the installation or water heater,
the remote controller will display a numerical error code.
Main remote controller model KGCMRCA
• KGCMRCA must be installed inside as it is NOT water
resistant.
• Allows the output temperature from the water heater to
be adjusted within the range of 37ºC to 55ºC.
• The temperature options are:
37ºC, 38ºC, 39ºC, 40ºC, 41ºC, 42ºC, 43ºC, 44ºC,
45ºC, 46ºC, 47ºC, 50ºC, 55ºC.
• When “BURNER ON” lamp is lit, the set temperature can
not be adjusted to 55ºC. If you wish to set it to 55ºC, you
should close the hot water tap.
• Where a tempering valve is installed, the temperature will
not be able to rise beyond the setting of the tempering
valve e.g. 50°C.
PRIORITY
°C
BURNER ON
To Next Page
Loading...
Need help?
General
