Kemper 345 - Feeding and Cutting Area

Service
Continued on next page KM00321,000029B 1924FEB101/4
Feeding and Cutting Area
Small dividers
CAUTION: Before carrying out adjustment or
service work, shut off engine and wait until all
moving parts have come to a stop.
For the crop to be taken in, properly gathered, cut and
fed further, it is essential that the parts listed below are
aligned with each other:
Feed teeth (C) move at a distance (G) of 25 mm (0.98 in.)
above the rotary cutter (B).
Distance (H) between the rear end of small divider (A) and
feed tooth (C) without welded cleaner must be between 4
and 6 mm (0.16 and 0.24 in.). The narrower the distance,
the easier it is to pick up down crop.
Distance (H) between the rear end of small divider (A)
and feed tooth (C) with welded cleaner must be approx.
1 mm (0.04 in.).
IMPORTANT: Straighten any feed teeth (C) deformed
by foreign bodies immediately.
The intake bars (E) must force the crop into the row of
closelyspaced teeth (D). Distance (J) between the end of
intake bar (E) and row (F) of teeth must be 28 mm (1.10
in.). If necessary, bend the intake bar to obtain distance
(J).
NOTE: When bending the intake bars, make sure
that total height (K) of the small divider is
approx. 185 mm (7.28 in.).
Have your KEMPER dealer replace any worn parts.
A—Small divider
B—Rotary cutter
C—Feed teeth
D—Row of teeth
E—Intake bar
F— Row of teeth
G—25 mm (0.98 in.)
H—4 to 6 mm (0.16 to 0.24 in.)
or approx. 1 mm (0.04 in.)
J— 28 mm (1.10 in.)
K—185 mm (7.28 in.)
ZX1040582 —UN—12APR07ZX012964 —UN—26NOV97
508
040810
PN=103