Kemper 345 - Length of Cut and Drum Speeds with KRONE Forage Harvester; Adjusting Harvesting Unit Lateral Float (Optional on 345 and 360, Standard on 375)

Operation of the Rotary Harvesting Unit
KM00321,00002A4 1924FEB101/1
OUCC002,00027DC 1917SEP071/1
Length of Cut and Drum Speeds with
KRONE Forage Harvester
See forage harvester Operator’s Manual for information
on lengthofcut adjustment.
IMPORTANT: To avoid damage to the rotary harvesting
unit, the drum speed of the KEMPER rotary
harvesting unit must not exceed 65 rpm.
KM1001136 —UN—24FEB10
Adjusting Harvesting Unit Lateral Float
(Optional on 345 and 360, Standard on 375)
Minor irregularities in the ground are absorbed and
balanced via the two tension springs (A). Normally, the
harvesting unit is somewhat overhung above the ground.
If harvesting unit is reacting insufficiently or excessively
hard to bumps in the ground, the tension springs can be
adjusted by turning the nuts (B).
•
Loosen nuts (B) for more floating effect.
•
Tighten nuts (B) for less floating effect.
Always lock nuts (B) after adjustment.
NOTE: Place the forage harvester on a flat ground before
adjusting the tension springs and make sure that
the harvesting unit is in a horizontal position.
A—Springs
B—Adjusting nuts
ZX1040576 —UN—12APR07
3025
040810
PN=77