Kemper 345 - Alternative and Synthetic Lubricants; Mixing Lubricants; Lubricant Storage; Every 10 Hours ­ U.J. Shaft

Lubrication and Maintenance
KM00321,0000197 1910JUN091/1
KM00321,0000198 1910JUN091/1
DX,LUBST 1918MAR961/1
KM00321,000028E 1924FEB101/1
Alternative and Synthetic Lubricants
Conditions in certain geographical areas may require
lubricant recommendations different from those printed in
this manual.
Some lubricants may not be available in your location.
Consult your KEMPER dealer to obtain information and
recommendations.
Synthetic lubricants may be used if they meet the
performance requirements as shown in this manual.
The temperature limits and service intervals shown in
this manual apply to both conventional and synthetic
lubricants.
Rerefined base stock products may be used if the
finished lubricant meets the performance requirements.
Mixing Lubricants
In general, avoid mixing different brands or types of oil.
Oil manufacturers blend additives in their oils to meet
certain specifications and performance requirements.
Mixing different oils can interfere with the proper
functioning of these additives and degrade lubricant
performance.
Consult your KEMPER dealer to obtain information and
recommendations.
Lubricant Storage
Your equipment can operate at top efficiency only when
clean lubricants are used.
Use clean containers to handle all lubricants.
Whenever possible, store lubricants and containers
in an area protected from dust, moisture, and other
contamination. Store containers on their side to avoid
water and dirt accumulation.
Make certain that all containers are properly marked to
identify their contents.
Properly dispose of all old containers and any residual
lubricant they may contain.
Every 10 Hours  U.J. Shaft
Lubricate with grease.
A—U.j. shaft, rotary harvesting
units for NEW HOLLAND,
CASE and KRONE forage
harvesters
B—U.j. shaft, rotary harvesting
units for CLAAS forage
harvesters
KM1001133 —UN—24FEB10
456
040810
PN=91