Kemper PROFILER Remote - Managing Effect Assignments; Assigning Effect Modules; Unassigning Effect Modules

11REMOTE QUICK START
ASSIGNING AN EFFECT MODULE
Assigning switching functions to the Eect Buttons is simple: just press and hold an Eect Button on the Remote for
example Eect Button IIII and press the desired module button, e.g. Module D, on the front panel of the PROFILER at
the same time. Done!
It also works the other way around: press and hold the module button on the PROFILER first, then step on the
desired Eect Button afterwards. The upper left LED of the Eect Button should now reflect the category color of
the eect you assigned e. g. orange for a wah eect. Now, you can activate or bypass the selected eect module by
stepping on the button on your PROFILER Remote. The lower left white LED indicates the on/o status of this eect
module.
UNASSIGNING AN EFFECT MODULE
To undo a current assignment, simply perform the same assignment procedure again. Gone! The upper LEDs remain
unlit if no eect is assigned.