Kemper PROFILER Remote - Multiple Effect Assignments; Toggling and Storing Effects

12 REMOTE QUICK START
ASSIGNING A SECOND EFFECT MODULE
To add a second assignment to the same Eect Button, just repeat the process with another eect module. You
will notice the right LEDs by the Eect Button indicate both the eect category and on/o state of your second
assignment. Now, you can activate or bypass both eects by stepping on the button on your PROFILER Remote.
MORE ASSIGNMENTS
Even more eect modules can be assigned to the same Eect Button this way. However, the LEDs will only show the
first two assignments.
TOGGLING EFFECTS
The Eect Buttons toggle the on/o states of each of their assigned eect modules independently, depending on
their current state. So, not only can you activate (or bypass) multiple eects simultaneously - you can also activate
some eect modules while bypassing others. The white LEDs will reflect this accordingly.
Example: Currently, eect module D is activated, and module X is bypassed. Both eect modules are assigned to
the same Eect Button. If you hit this Eect Button, module D will be bypassed, and module X will be activated. This
allows you to toggle between dierent eect scenes.
STORING ASSIGNMENTS
Once you are happy with the assignments and the current on/o states, then simply store the Rig. All assignments
that you have created are stored with the individual Rig. Whenever you load this Rig later, the assignments and the
on/o states are recalled just as they were when you stored the Rig.