Kemper Profiling Amplifier - Stomps; Stomp LED color coding

KEMPER PROFILING AMPLIFIER12
Stomps
The first section, labeled “STOMPS”, is for your stomp box eects. This section oers four stomp box slots
which are represented by the four buttons labeled A, B, C, and D. Here you can place the built-in stomp
eects in any order and configuration you’d like. These eects are applied before the signal reaches the
STACK section.
 Stomp LED color coding
You’ll notice that the stomp LEDs aren’t simply lit green or not, but have many dierent colors. That’s be-
cause these LEDs use color to help you identify which kind of algorithm is being used for each stomp.
Stomp algorithms are color coded like this:
Distortion Red
Wah Orange
Chorus Blue
Phaser & Flanger Purple
Compressor Cyan
EQ Yellow
Delay Green
Eect Loop White
You can change the algorithm for a stomp that is shown in the display by rotating the TYPE knob above
the left side of the display to scroll through the available algorithms. The BROWSE knob above the right
side of the display can be used to select items from lists of “local presets” that are available for every
stomp. Local presets are settings for a specific type of module (stomps and eects), stored independent
from the rig itself.