Kemper Profiling Amplifier - Effects section; X; Mod; Delay

KEMPER PROFILING AMPLIFIER30
wards the left most position, the sound will resemble that of analog cabinet simulations (which often have
a very limited frequency response and little character).
Eects section
The Eects section is where you can add stereo eects after (post-) the mono stomps section and the
amp stack. It consists of the following modules:
 X
The X stomp can use the same eects as the stomp boxes, but in stereo, which is especially useful with ef-
fects like chorus that spread the sound over the stereo image.
 Mod
MOD can also use the same eects as the stomp boxes. However, this module is equipped with hardware
controls which are designed to work specifically with modulation eects such as Chorus, Flanger, Phaser
or Rotary. For this reason we recommend saving this slot for these types of eects. Modulation rate and
intensity can be controlled using the dedicated RATE and INTENSITY knobs.
 Delay
These are the built-in delay eects. You can determine the stereo placement of the delay signals, the
rhythmic values of the repeats, and also the character of their sound. Delay feedback and mix can be con-
trolled conveniently using the dedicated hardware controls.