MAKING CONNECTIONS 47
The KPA can only accurately profile preamp stomp boxes such as overdrive and distortion pedals, Eqs and
filters, tube preamp pedals, and so on. Attempting to profile a delay, reverb or modulation pedal is unlikely
to work as expected. In other words: your mileage might vary.
Connections for profiling a computer-based guitar amp
simulation
• Connect your guitar to the INPUT of the KPA.
• Connect the DIRECT OUTPUT/SEND from the KPA to the appropriate input on your computer’s audio in-
terface.
• Route the output of your guitar amp simulation software to a specific hardware output of your computer’s
audio interface.
• Connect the output in question to the RETURN INPUT of the KPA.
When profiling a guitar amp simulation, be sure to switch o the noise gate in your guitar amp simulation
software.
To Next Page
Loading...
