Kemper ProfiMaster - English

KEMPER ProfiMaster Instruction Manual - EN
Product number: 150 2464 - 37 - rev.: 2
Technical changes and errors reserved.
Status as of: 05/2015
Table of Contents
1 GENERAL INFORMATION ............................................................................... 39
1.1 Introduction .................................................................................................. 39
1.2 Advise Regarding Copyrights and Protection Rights .............................. 39
1.3 Information for the Operators ..................................................................... 40
2 SAFETY ............................................................................................................ 41
2.1 General information ..................................................................................... 41
2.2 Information about signs and symbols ....................................................... 41
2.3 Signs and labels required to be installed by the operator ....................... 42
2.4 Safety instructions for the operating personnel ....................................... 42
2.5 Safety instructions for maintenance and troubleshooting on
the ProfiMaster device ................................................................................. 43
3 PRODUCT DESCRIPTION ............................................................................... 44
3.1 Distinguishing features of the device variants ......................................... 46
3.2 Use in accordance with the intended purpose .......................................... 47
3.3 Reasonably foreseeable misuse ................................................................ 48
3.4 Markings and labels on the ProfiMaster device ........................................ 49
3.5 Residual risk ................................................................................................ 51
4 TRANSPORT AND STORAGE ......................................................................... 52
4.1 Transport ...................................................................................................... 52
4.2 Storage ......................................................................................................... 52
5 INSTALLATION ................................................................................................ 53
5.1 Unpacking and installing wheels................................................................ 53
5.2 Exhaust arm installation ............................................................................. 54
6 USE ................................................................................................................... 55
6.1 Qualification of operating personnel ......................................................... 55
6.2 Control elements.......................................................................................... 55
6.3 Adjusting the position of the extraction nozzle ........................................ 58
6.4 Putting into operation .................................................................................. 58