Kemper ProfiMaster - 5 Installation; Unpacking and Installing Wheels

KEMPER ProfiMaster Instruction Manual - EN
Product number: 150 2464 - 53 - rev.: 2
Technical changes and errors reserved.
Status as of: 05/2015
5 Installation
CAUTION
Severe injury when mounting the exhaust arm due to the
pretension of coil springs. Improper handling may result in
unexpected movement of the support structure and severe facial
injuries or contusions of fingers!
NOTE
The operator may charge with assembly of the ProfiMaster device only
the persons who are well familiarized with this activity.
The device assembly requires two operators.
5.1 Unpacking and installing wheels
• Take the set of wheels (6430007) out from packing (of putting on type)
• Now lift the large packaging.
• The ProfiMaster device stands on the cardboard box bottom and is bolted to
the pallet by means of two metal brackets. Cut the corners of the cardboard
box bottom with a knife to be able to fold the sides. To ensure complete
removal of the transport fixtures, loosen the bolts of the metal brackets and
remove the two bigger screws.
• The set of wheels contains all wheels, including all minor components required
for installation and a separate pictorial manual for installation of the wheels.
• Follow this manual when performing the installation.
• Open the service door and check the status and proper placement of the filter
elements. See also the instructions in Section 7.3 Filter replacement.