Kemppi FASTMIG MS 200 - Page 17

15
© Kemppi Oy / R03
EN
MiniLog Level
MLo -99 ... +200% 50%
Set the minilog power level as a
percentage of the welding power
Synergic Start Time
FSt -9 ... +9 0 Star time in WiseRoot/WiseThin welding
Synergic Start
Voltage
FuL -30 ... +30 0 Voltage level in the beginning of
WiseRoot/WiseThin welding
Start Power
StA -9 ... +9 0 Strength of start pulse
(not in WiseRoot or WiseThin)
Post Current Time
PoC -9 ... +9 0 Post current
Synergic MIG Unit
Unl m/min, mm, A m/min In 1-MIG and WiseRoot welding, the
parameter shown in left-hand display:
wire feed speed (m/min), sheet thickness
(mm) or average current (A)
Arc Voltage
Ard OFF, on OFF on: Display shows arc voltage
OFF: Display shows pole voltage
(not in WiseRoot or WiseThin)
Cable Length
CAb std, 5 – 80m std Cable loss is calculated for optimal arc
control and for the Arc Voltage display
(not in WiseRoot or WiseThin)