EN
1.3 Operation Safety
Please read and follow these operational safety instructions when installing, operating and
servicing the welding gun.
Welding arc and welding spatter
Welding arc can harm unprotected eyes. Also be aware of the risks to other people in and
around the working area, as reected arc and arc ash presents a serious risk. Welding arc
and hot spatter will burn unprotected skin. Use specied, good quality safety equipment and
protective clothing.
Danger for re or explosion
Observe the local re safety regulations and complete an adequate risk assessment, prior to
commencing work. Remove ammable or explosive materials from welding place. Always
ensure there is adequate re-ghting equipment available. Be aware of welding hazards eg.
the danger of re or explosion when welding container type work pieces or enclosed spaces.
NOTE! Fire can start from welding sparks and hot spatter, even several hours after the welding
work has nished!
Mains voltage
Never take the welding machine inside a work piece (eg. container or truck). Do not place
the welding machine on a wet surface. Always check cables before operating the machine.
Change defective cables without delay. Defective cables may cause an injury or increase
the risk of re. Connection cables and hoses should be protected from damage from heavy
objects, sharp edges or hot work pieces.
Welding power circuit
Protect yourself by using proper protective clothing suitable for the welding application
and environment. Do not work in wet or damp conditions. Do not wear wet clothing when
welding. Never use equipment with defective or damaged cables. Unless in a designed gun
holder, do not place the welding gun on the welding machine if the machine is live. Never
point the welding gun towards your face or that of others.
Welding fumes
Ensure there is sucient ventilation during welding. Observe safety recommendations and
precautions when welding metals which contain lead, cadmium, zinc, mercury or beryllium
and other harmful substances. Ensure you use appropriate protective respiratory equipment
suitable for the welding application, environment and materials being welded.
FE 20, 25, 27, 32, 35, 42
4
To Next Page
Loading...
Need help?
General
