To Next PageTo Next Page
Need help?Do you have a question about the Kemppi FastMig X 450 and is the answer not in the manual?
General| Input Voltage | 3 x 400 V |
|---|---|
| Output Current Range | 10 - 450 A |
| Duty Cycle at 40°C | 60% at 450 A |
| Protection Class | IP 23 |
| Power Supply | 3-phase |
| Wire Diameter Range | 0.8 - 1.6 mm |
| Welding Processes | MIG/MAG, MMA |
| Cooling Method | Air-cooled |
General information about the welding equipment and the FastMig X 450 model.
Instructions for checking the machine for transport damage and the operating environment.
Details electrical compliance and short-circuit power requirements for the supply network.
Identifies machine parts and provides guidelines for safe placement and cooling.
Schematic diagram and list of connections for a water-cooled setup.
Schematic diagram and list of connections for an air-cooled setup.
Guidance on multi-machine cable placement and mains power connection.
Recommendations for cable choice and wire feeder interconnection for performance.
How to use the main switch, interpret pilot lamps, and understand fan operation.
Using MMA, CC, CV modes and connecting external devices.
Overview of the X 37 control panel's physical layout and button functions.
Guide to using the menu for language selection and memory channel management.
Steps for creating and modifying memory channels for welding jobs.
Information on overload protection, fuses, and effects of voltage fluctuations.
Routine checks and cleaning tasks for daily and periodic maintenance.
Maintenance tasks performed by authorized Kemppi service personnel.
