Need help?Do you have a question about the Kemppi KEMPOMAT 220 and is the answer not in the manual?
General| Welding Process | MIG/MAG |
|---|---|
| Wire Feed Speed | 2 - 18 m/min |
| Protection Class | IP23 |
| Input Voltage | 400 V |
| Output Current | 220 A |
| Duty Cycle | 40 % |
| Output at 40% ED | 220 A |
| Output at 60% ED | 180 A |
| Output at 100% ED | 140 A |
| Wire Sizes | 1.2 mm |
Proper placement considerations for the welding machine, avoiding drafts and moisture.
Instructions for safely lifting the welding machine, ensuring gas cylinder removal.
Connecting the mains cable to the machine's terminal block and strain relief.
Procedure for switching between 380V and 220V input voltages.
Recommended shielding gases for different metals and flow rate.
Connecting the multi-function connector of the welding gun.
Installing the wire conduit within the welding gun's cable.
Connecting the work clamp securely for proper welding operation.
Adjusting welding voltage using coarse and fine controls, not during welding.
Setting the stepless wire feed speed from 0-16 m/min.
Maintenance for the welding gun, including gas nozzle and contact tip.
Checking feed roller wear and wire liner alignment.
Cleaning internal parts and checking electrical connections.
Detailed service for welding gun, gas nozzle, and contact tube.
Checking wire feed drive wear and cleaning the wire liner.
Cleaning internal components and inspecting electrical connections.
To Next Page