EN
2.4 Accessories corresponding to wire diameter
Colour coded wire feed rolls and guide tubes are available to suit a variety of ller wire types
and sizes. Drive roll groove geometry and design, vary depending on the application. Further
details are available in the spare parts tables.
Please ensure you select the correct drive rolls and guide tubes from the table to suit your
particular welding application.
2.5 Welding gun selection
Please ensure that the welding gun selected is suitable for the target application. Check the
gun manufacturers specication and ensure the gun meets the welding duty requirements.
Also consider the extra heating eects of Pulse MIG/MAG welding on the gun selected.
Kemppi gun products are designed to meet many dierent applications. Special wire liners
and contact tips are available for dierent wire types and sizes.
Distance wire feeding is accommodated with WeldSnake and SuperSnake products in either
Gas or Water cooled models.
Thermal and load protection is also designed to some Kemppi Gun models and feed units, so
carefully consider your requirements and consult your local Kemppi sales team to ensure you
choose the correct alternative for your needs.
2.6 Mounting and locking of wire spool
NOTE! Check that in ller wire spool is correctly mounted and locked into position. Ensure the spool
is not damaged or deformed in such a way that it can rub or cha against the internal surface of
the wire feed unit chassis or door. This may result in increased drag, impacting on weld quality. This
may also result in long term wire feed unit damage, rendering the unit unserviceable or unsafe to
use.
7
© Kemppi Oy / 1336
To Next Page
Loading...
Need help?
General
