How to troubleshoot Kemppi Welding System that does not power up?
If your Kemppi Welding System doesn't power up, verify that the mains cable is correctly plugged in and the power source's mains switch is in the ON position. Also, ensure the mains power distribution is active and inspect the mains fuse or circuit breaker. Check the interconnection cable between the power source and wire feeder and verify the earth return cable is connected.
What to do if Kemppi Master M 205 stops working during operation?
If the Kemppi Welding System stops working, it might be due to overheating. If you're using a gas-cooled gun, allow it to cool down. For the wire feeder or power source overheating, let them cool, ensure the welding current cable is properly attached (wire feeder), and confirm the cooling fans are working correctly with unobstructed airflow (power source). Also, check all cables to make sure none are loose.
Why is there a high spatter volume with my Kemppi Welding System?
If you're experiencing high spatter volume with your Kemppi Welding System, begin by checking the welding parameter values and the welding procedure. Also, check the gas type and flow, and verify the polarity of the gun/electrode. Finally, ensure that the filler wire is correct for the current application.
Why is the welding performance of my Kemppi Master M 205 Welding System varying?
If you notice varying welding performance with your Kemppi Welding System, check that the wire feed mechanism is adjusted properly. Blow compressed air through the wire liner to ensure it's not blocked. Verify the wire liner is correct for the selected wire size and type. Inspect the welding gun contact tip for size, type, and wear. Ensure the welding gun isn't overheating and that the earth return clamp is properly attached to a clean surface on the workpiece.
What to do if the Kemppi Welding System wire feed mechanism isn't feeding wire?
If the wire feed mechanism on your Kemppi Welding System isn't feeding the filler wire, first check that the filler wire hasn't run out. Then, ensure the filler wire is properly routed through the feed rolls to the wire liner and that the pressure handle is correctly closed. Also, verify the feed roll pressure is appropriately adjusted for the filler wire. Check the welding cable's connection to the wire feeder, and blow compressed air through the wire liner to clear any blockages.
How to troubleshoot dirty or poor quality weld with Kemppi Master M 205?
If you're getting dirty or poor-quality welds with your Kemppi Welding System, check that the shielding gas hasn't run out and that the shielding gas flow is unobstructed. Also, make sure the gas type is correct for the application, and verify the polarity of the gun/electrode. Finally, confirm that the welding procedure is correct for the application.
Why does the filler wire on the spool unravel on my Kemppi Welding System?
If the filler wire on the spool of your Kemppi Welding System is unraveling, check that the spool locking cover is closed.
General| Brand | Kemppi |
|---|---|
| Model | Master M 205 |
| Category | Welding System |
| Language | English |
To Next Page